Construction Material Stainless Steel Cage Making Machine ≤ 4M

Deasription:

Wire cage welding machine is a special-purpose welder used to produce the high-strength concrete pipe pile reinforcement cages. The welder is widely applied to reinforcement cage welding by self-stressing and prestressing pretensioning method and post-tensioning method.

1. Large diameter of weldable main reinforcement, long frame, small torsion and good integral performance;

2. Small weld strength loss;

3. Adjustable cage pitch and quick forming;

4. High-speed and stable operation and high efficiency;

5. Variable frequency control and high stability and reliability;

6. Rational structure and easy and convenient operation and maintenance.

Application:

This machine is the Special-purpose welding equipment for making the steel wire cages for the Reinforced concrete drainage pipes, it is capable to weld the Reinforcement cages with Socket&Spigot ends, and Flush or male& female ends. It is one of the main equipments to manufacture the Reinforced concrete pipes.

Features:

1. With small tolerance and good forming quality, automatic rebar Wind up mechanism can adjust the space between rebars in operation.

2. Automatic welding, accurate solder joint and labor intensity reduction.

3. Frequency converter controlled high precision Cage-drawing system.

4. Automatic cage holding design can prevent the cage from bending accident, which is caused by its weight in the middle of welding.

5. Automatic loading mechanism can speed up the loading rate and increase productivity.

6.The mould consists of moulding ring and conduit, which can adjust cage diameter and main rebar quantity fastly.

7. Forward and reverse roll type straightening mechanism with characteristics of long service life and good straightening effect.

8. Controlling system consists of Panasonic PLC, Panasonic touch screen, ABB frequency converter.

Announcements :

1. this machine should use cold-drawn and low-carbon steel with the non-oxidation, no rustiness and oil stains. Its diameter should not be over that stated parameter values, otherwise it will damage to the welders. When welding steel with 7-8mm diameter, you should low down the speed, in case producing too much heat to the welding machine.

2. Assure the Groove of conductive cooper bush on the Welders coincide with the diameter of Latitude steel, otherwise it will be difficult to put and push through the steel wire.

3. check-up the cooling water system: turn on the water pump, look over if there is water in the water tube, and water flow rate is enough, or else clean the water cycle system.

4. when you use the machine for the first time, please let it empty running, and you should make everything go on well, without loose and abnormal noise and liberation.

5. Please not use the machine when it rains and with thunder, and please turn off the total electrical power.

Worksit:

Shippng: